Filter
Top Products
1 - 6 IMAGETEAM™ 2020/4620 System Manual
Connecting the Base with RS-232 Serial Port
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the base.
Note: For the base to work properly, you must have the correct cable for your
type of terminal/computer.
3. Unplug the mouse or keyboard from the computer. Plug the mouse or
keyboard into the power tap on the imager cable.
4. Plug the power tap into the mouse or keyboard port.
5. Plug the serial connector into the serial port on your computer. Tighten the
two screws to secure the connector to the port.
6. Once the imager has been fully connected, power up the computer.
3
4
5
2
5
4
3
2