Filter
Top Products
1 - 8 IMAGETEAM™ 2020/4620 System Manual
Linking Imager to Base
When newly shipped or defaulted to factory settings, the base and imager are not
linked. Once the imager is placed into the base, the software automatically links
the imager and the base. If the imager and base have previously been linked,
you do not receive any feedback. If this is the first time that the imager and base
are linked, both devices emit a short chirp when their radios link. At this point,
you are set to one imager to one base.
1. Provide power to the base.
2. Place the IT4620 into the base. The imager and base link.
3. To determine if your cordless system is set up correctly, scan one of the
sample bar codes in the back of this manual. If the imager provides a single
good read beep and the green LED lights, the imager has successfully linked
to the base. If you receive a triple error beep and the red LED lights, the
imager has not linked to the base.
IT4620 Imager
IT2020-5B Cordless Base
Green LED
Red LED