Filter
Top Products
3 - 12 IMAGETEAM™ 2020/4620 System Manual
Out-of-Range Alarm
Duration
If your imager is out range of the base, an alarm sounds from both your base and
imager. To activate the alarm options for the imager or the base and to set the
alarm duration, scan the appropriate bar code below and then set the time-out
duration (from 0-3000 seconds) by scanning digits on the Programming Chart
inside the back cover, then scanning Save.
Default = 0 sec (no alarm).
Note: If you are out of range when you scan a bar code, you will receive an error
beep even if you do not have the alarm set. You receive the error beep
since the data could not be communicated to the base or the host.
Alarm Sound Type
If you have set the out-of-range alarm enabled, you may change the alarm type
for the imager or base by scanning the appropriate bar code below and then
scanning a digit (0-7) bar code and the Save bar code on the Programming Chart
inside the back cover of this manual.
Default = 0.
Set the sound type to fit your
application.
Base Alarm Duration
Imager Alarm Duration
Base Alarm Type
Imager Alarm Type