Filter
Top Products
1-7
Introducing the HP ProCurve Series 2300 and 2500 Switches
Back of the Switches
Introducing the HP ProCurve
Series 2300 and 2500
Clear Button (Series 2500 only)
This button is used for these purposes:
■ Deleting Passwords - When pressed by itself for at least one second, the
button deletes any switch console access passwords that you may have
configured. Use this feature if you have misplaced the password and need
console access.
This button is provided for your convenience, but its presence means
that if you are concerned with the security of the switch configuration
and operation, you should make sure the switch is installed in a secure
location, such as a locked wiring closet.
■ Restoring Factory Default Configuration - When pressed with the
Reset button in a specific pattern, any configuration changes you may
have made through the switch console, the web browser interface, and
SNMP management are removed, and the factory default configuration is
restored to the switch. For the specific method to restore the factory
default configuration, see “Restoring the Factory Default Configuration”
in chapter 3, “Troubleshooting” of this manual.
Back of the Switches
.
Power Connector
The Switch 2300 and Switch 2500 models do not have a power switch; they
are powered on when connected to an active AC power source. The switches
automatically adjust to any voltage between 100-127 and 200-240 volts and
either 50 or 60 Hz. There are no voltage range settings required.
cooling vent - make sure this is not
obstructed for proper switch operation
AC power connector
2353-ed2.book Page 7 Friday, February 9, 2001 6:00 PM