Filter
Top Products
Optimizing Traffic Flow with Port Controls, Port Trunking, and Filters
Viewing Port Status and Configuring Port Parameters
Configuring a Broadcast Limiting on the Switch. Executing this com-
mand configures broadcast limiting for all ports on the switch.
Syntax: broadcast-limit
HPswitch(config)# broadcast-limit
To display the current broadcast limit setting, use one of the following com-
mands:
HPswitch# show config Displays the startup-config file. The
broadcast limit setting appears here
if enabled and saved to the
startup-config file.
HPswitch# show running-config Displays the running-config file.
The broadcast limit setting appears
here if enabled. If the setting is not
also saved to the startup-config file,
rebooting the switch returns broad
cast limit to the setting currently in
the startup-config file.
Web: Viewing Port Status and Configuring Port
Parameters
In the web browser interface:
1. Click on the Configuration tab.
2. Click on
.
3. Select the ports you want to modify and click on
.
4. After you make the desired changes, click on
.
Note that the web browser interface displays an existing port trunk group.
However, to configure a port trunk group, you must use the CLI or the menu
interface. For more on this topic, see
“Port Trunking” on page 9-10.
9-9