Filter
Top Products
IP Routing Features
Configuring OSPF
OSPF Trap Name MIB Object
originate-lsa-trap ospfOriginateLsa
originate-maxage-lsa-trap ospfMaxAgeLsa
link-state-database-overflow-trap ospfLsdbOverflow
link-state-database-approaching-overflow- ospfLsdbApproachingOverflow
trap
Examples:
1. To stop an OSPF trap from being collected, use the following CLI
command:
HPswitch(ospf)#no trap <ospf-trap>
2. To disable reporting of the neighbor-state-change-trap, enter the following
command:
HPswitch(ospf)#no trap neighbor-state-change-trap
3. To reinstate the trap, enter the following command:
HPswitch(ospf)# trap neighbor-state-change-trap
Syntax: [no] snmp-server trap ospf <ospf-trap>
Modify OSPF Standard Compliance Setting
Not e All routes in an AS should be configured with the same compliance setting. If
any routers in a domain support only RFC 1583, then all routers must be
configured with 1583 compatibility.
If all the routers support RFC 2178 or RFC 2328, you should disable RFC 1583
compatibility on all the routers in the domain, since these standards are more
robust against routing loops on external routes.
HP Series 5300XL Switches are configured, by default, to be compliant with
the RFC 1583 OSPF V2 specification.
To configure a Series 5300XL Switch to operate with the latest OSPF standard,
RFC 2328, enter the following commands:
HPswitch(config)# router ospf
HPswitch(ospf)# no rfc1583-compatibility
Syntax: [no] rfc1583-compatibility
16-51