Filter
Top Products
--------------- ----------- ---------------------
IP Routing Features
Configuring RIP
Displaying General RIP Information
To display general RIP information, enter the following CLI command at any
context level:
HPswitch# show ip rip
The resulting display will appear similar to the following:
RIP global parameters
RIP protocol : disabled
Auto-summary : disabled
Default Metric : 1
Route changes : 0
Queries : 0
RIP interface information
IP Address Status Send mode Recv mode Metric Auth
--------------- ----------- ---------------- ---------- ----------- ----
100.1.0.1 enabled V2-only V2-only 1 none
100.2.0.1 enabled V2-only V2-only 1 none
100.3.0.1 enabled V2-only V2-only 1 none
100.4.0.1 enabled V2-only V2-only 1 none
100.10.0.1 enabled V2-only V2-only 1 none
100.11.0.1 enabled V2-only V2-only 1 none
100.12.0.1 enabled V2-only V2-only 1 none
RIP peer information
IP Address Bad routes Last update timeticks
The display is a summary of Global RIP information, information about
interfaces with RIP enabled, and information about RIP peers. The following
fields are displayed:
RIP protocol – Status of the RIP protocol on the router. RIP must be
enabled here and on the VLAN interface for RIP to be active. The default
is disabled.
Auto-summary – Status of Auto-summary for all interfaces running RIP.
If auto-summary is enabled, then subnets will be summarized to a class
network when advertising outside of the given network.
16-27