Filter
Top Products
IP Routing Features
Configuring RIP
The information in this display includes the following fields, which are defined
under ““RIP Interface Information” on
page 16-28: IP Address, Status, Send
mode, Recv mode, Metric, and Auth.
The information also includes the following fields:
Bad packets received – The number of packets that were received on
this interface and were not processed for any reason.
Bad routes received – The number of route entries that were received
on this interface and were not processed for any reason.
Sent updates – The number of RIP routing updates that have been sent
on this interface.
Displaying RIP interface information by IP Address: For example, to
show the RIP interface information for the interface with IP address 100.2.0.1,
enter the following command:
HPswitch# show ip rip interface 100.2.0.1
RIP interface information for 100.2.0.1
IP Address : 100.2.0.1
Status : enabled
Send mode : V2-only
Recv mode : V2-only
Metric : 1
Auth : none
Bad packets received : 0
Bad routes received : 0
Sent updates : 0
The information shown in this display has the same fields as for the display
for a specific VLAN ID. See the previous page for the definitions of these fields.
Syntax: show ip rip interface [ip-addr | vlan vlan-id]
Displaying RIP Peer Information
To display RIP peer information, enter the following CLI command at any
context level:
HPswitch# show ip rip peer
16-30