Filter
Top Products
IP Routing Features
Configuring OSPF
An example of the show ip ospf external-link-state advertise is the following:
OSPF External LSAs
Advertisements
------------------------------------------------------------------------
000302050a0307000a00082580000005d99f0024ffffff008000000a0000000000000000
000302050a0308000a00082580000005cea90024ffffff008000000a0000000000000000
000302050a0309000a00082580000005c3b30024ffffff008000000a0000000000000000
000302050a030a000a00082580000005b8bd0024ffffff008000000a0000000000000000
000002050a0321000a000824800009cdb9dd0024ffffff00800000010000000000000000
Displaying OSPF Interface Information
To display OSPF interface information, enter the following command at any
CLI level:
HPswitch# show ip ospf interface
OSPF Interface Status
IP Address Status Area ID State Auth-type Cost Priority
--------------- -------- --------------- ------- --------- ------ ---------
10.3.18.36 enabled 10.3.16.0 BDR none 1 1
10.3.53.36 enabled 10.3.48.0 BDR none 1 1
Syntax: show ip ospf interface [vlan <vlan-ID> | <ip-addr>]
The OSPF interface display shows the following information:
Table 16-6. CLI Display of OSPF Interface Information
This Field... Displays...
IP Address
The local IP address for this interface.
Status
enabled or disabled - whether OSPF is currently enabled
on this interface
.
Area ID The ID of the
area that this interface is in.
16-56