Filter
Top Products
8 Installation Guide
G:\TW\Lori\Raptor\C4388-90100\exraptor1.fm Page 8
Last Modified: Tuesday, January 27, 1998 8:33 pm
Printing date: Saturday, April 04, 1998
7. Attach the cable’s remaining connector to the tape drive and secure it by tightening
the retaining screws.
If You Have Problems
After connecting your tape drive and turning on your computer, the computer should
start (boot) as it normally does. If it does not, check the following items:
n
Is the computer power cord plugged in?
n
Is each device plugged in and turned on?
n
Are all cables properly plugged into the back of your computer?
n
If you verify all of these and still have problems, try turning off your computer.
Wait at least 20 seconds before turning it back on.
n
If you have a printer connected to the HP Colorado tape drive, turn off the
computer’s power. Disconnect the tape drive and the printer. Reconnect only
your tape drive to the parallel port, then turn the computer on and start Colorado
Backup. If tape drive works, it is likely you have a conflict with the printer.
Tape-drive data cable
Printer cable
(Only if you are sharing the
port with a printer)