Filter
Top Products
TM 11-6625-2965-14&P
C-3. Column Entries
a. Column 1, Group Number. Column 1 lists
group numbers, the purpose of which is to identify
components, assemblies, subassemblies, and mod-
ules with the next higher assembly.
b. Column 2, Component/Assembly. Column 2
contains the noun names of components, assem-
blies, subassemblies, and modules for which main-
tenance is authorized.
c. Column 3, Maintenance Functions Column 3
lists the functions to be performed on the item
listed in column 2. When items are listed without
maintenance functions, it is solely for purpose
of having the group numbers in the MAC and
RPSTL coincide.
d. Column 4, Maintenance Category. Column 4
specifies, by the listing of a “worktime” figure in
the appropriate subcolumn (s), the lowest level of
maintenance authorized to perform the function
listed in column 3. This figure represents the ac-
tive time required to perform that maintenance
function at the indicated category of maintenance.
If the number or complexity of the tasks within
the listed maintenance function vary at different
maintenance categories, appropriate “worktime”
figures will be shown for each category. The num-
ber of task-hours specified by the “worktime”
figure represents the average time required to
restore an item (assembly, subassembly, compo-
nent, module, end item or system) to a serviceable
condition under typical field operating conditions.
This time includes preparation time, troubleshoot-
ing time, and quality assurance/quality control
time in addition to the time required to perform
the specific tasks identified for the maintenance
functions authorized in the maintenance allocation
chart. SubColumns of column 4 are as follows:
C - Operator/Crew
0- Organizational
F- Direct Support
H - General Support
D - Depot
e. Column 5, Tools and Equipment. Column 6
specifies by code, those common tool sets (not
individual tools) and special tools, test and sup-
port equipment required to perform the designated
function.
f. Column 6, Remarks. Column 6 contains an
alphabetic code which leads to the remark in
section IV, Remarks, which is pertinent to the
item opposite the particular code.
C-4. Tool and Test Equipment Requirement
(sect Ill)
a. Tool or Test Equipment Reference Code. The
numbers
in this column coincide with the numbers
used in the tools and equipment column of the
MAC. The numbers indicate the applicable tool
or test equipment for the maintenance functions.
b. Maintenance Category. The codes in this
column indicate the maintenance category allo-
cated the tool or test equipment.
c. Nomenclature. This column lists the noun
name and nomenclature of the tools and test
equipment required to perform the maintenance
functions.
d. National/NATO Stock Number. This column
lists the National/NATO stock number of the
specified tool or test equipment.
e. Tool Number. This column lists the manu-
facturer’s part number of the tool followed by the
Federal Supply Code for manufacturers (5-digit)
in parentheses.
C-5. Remarks (sect IV)
a. Reference Code. This code refers to the ap-
propriate item in section II, column 6.
b. Remarks. This column provides the required
explanatory information necessary to clarify items
appearing in section II.
C-2