Filter
Top Products
Manual Changes/Model 6205B
TM 11-6625-2965-14&P
DESCRIPTION
Front Panel, Lettered
Chassis, Right Side
Chassis, Left Side
Cover, Top
Rack Kit (accessory)
Heatsink
ERRATA:
STANDARD
06205-00005
5060-7956
5060-7955
5000-9424
14523A
06205-60005
In parts list, change HP Part No. of rubber bumper
(qty. 4) to 0403-0002.
In Figure 5-4, change Rx value listed for Model
6206B to 3 ohms.
In Table 1-1, change the INTERNAL IMPEDANCE
AS A CONSTANT VOLTAGE SOURCE (Output Impe-
dance) specification to read as follows:
Output Impedance (Typical): Approximated
by a 25 milliohm resistance in series with a 1
micro henry inductance.
The standard colors for this instrument are now
mint gray (for front panel) and olive gray (for
all other external surfaces). Option X95 desig-
nates use of the former color scheme of light
gray and blue gray.
Option A85 designates use
of a light gray front panel with olive gray used
for all other external surfaces. New part numbers
shown above.
In Figure 3-9, delete the six references to TP23.
These wires must be connected in the appropriate
power supply directly to the end of R54 that is
towards the rear of the supply. Another correction
needed in this figure is that the wire from terminal
A6 in Slave No. 1 in the two-unit example at the
top of the figure should be connected to the rear
of R54 in the master supply. Note: The range
switches of the master and slave supplies must
be set to the same range when operating in auto-
parellel.
HP PART NO.
OPTION A85
OPTION X95
5060-6118
5060-6119
5000-6061
06205-60002
ERRATA:
Effective January 1, 1977, Option 007 (1O-turn
voltage control) has been redesignated Option 009,
and Option 013 (1 O-turn voltage control with deca -
dial) has been redesignated Option 015. Make
these changes wherever Option 007 or 013 is men-
tioned in the manual.
The front panel binding posts have been changed to
a type with better designed insulation.
Delete the
two types of posts listed on page 6-6 of the parts
list and add :
black binding post, HP Part No. 1510-
0114 (qty. 4); and red binding post HP Part No.
1510-0115 (qty. 2).
● The corrugated shipping carton for this model has
been changed to HP Part No. 9211-2570. Two
9220-2703 floater pads are used.
The blue-gray meter bezel has been replaced by a
black one, HP Part No. 4040-0414.
8-5-77
Add to the parts list the replacement lamp for
illuminated switch 3101-1248, which is used in
those supplies that include Change 2. The HP
Part No. of the type A1H lamp is 2140-0244.
D-6
06205-60004
14523A-A85