Filter
Top Products
Removal and Replacement Procedures 19
CAUTION: Do not operate the server for long periods without
the access panel. Operating the server without the access panel results
in improper airflow and improper cooling that can lead to thermal
damage.
1. Power down the server if performing a non-hot-plug installation or
maintenance procedure ("Powering Down the Server" on page 16
).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 17
).
3. Lift up on the hood latch handle and remove the access panel.
Hot-Plug SCSI Hard Drive
To remove the component:
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
1. Determine the status of the hard drive from the hot-plug hard drive LEDs
("Hot-Plug SCSI Hard Drive LEDs" on page 89
).
2. Back up all server data on the hard drive.
3. Remove the hard drive.