Filter
Top Products
Removal and Replacement Procedures 27
1. Slide the power supply blank into the bay until it locks into place.
2. Swing the cable management arm into place and lock it.
Hot-Plug Fan
To remove the component:
1. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 17
, "Removing the Server from the Rack" on page 18).
2. Remove the access panel ("Removing the Access Panel" on page 18
).
3. Determine whether the fan is operating with redundancy:
− If the fan zone is not operating with redundancy, power down the server
("Powering Down the Server" on page 16
).
− If the fan zone is operating with redundancy, continue with the next step.
For information on fan redundancy, refer to "Redundant Hot-Plug Fan
Option (on page 93
)."
4. Remove the fan.