Filter
Top Products
26 HP ProLiant DL560 Server Maintenance and Service Guide
2. Slide the power supply into the power supply bay.
3. Connect the power cord to the power supply.
4. Route the power cord through the cable management arm or power cord
anchor.
NOTE: If using the power cord anchor, be sure to leave enough slack
in the power cord so that the redundant power supply can be removed
without disconnecting the power cord from the primary power supply.
5. Lock the cable management arm into the operating position.
Power Supply Blank
To remove the component:
1. Unlock the hinge on the cable management arm and swing the arm away
from the power supply area.
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
2. Remove the power supply blank.
To replace a power supply blank: