Filter
Top Products
46 HP ProLiant DL560 Server Maintenance and Service Guide
CAUTION: To prevent possible server malfunction or damage
to the equipment, be sure to completely close the processor locking
lever.
PPM
To remove the component:
1. Power down the server ("Powering Down the Server" on page 16
).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 17
, "Removing the Server from the Rack" on page 18).
3. Remove the access panel ("Removing the Access Panel" on page 18
).
NOTE: The appearance of compatible PPMs may vary.
4. Remove the PPM.
IMPORTANT: PPM slots must be populated when processors are
installed. If PPM slots are not populated, the server does not boot or
halts during POST.
To replace the component, reverse the removal procedure.