Filter
Top Products
Continued...
1-2
Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen
This is the cyan on page 1-2 (seq: 20)
This is the black on page 1-2 (seq: 20)
Fast Track
If You Meet All the Following Requirements:
You want English as the language of the front-panel display and of the plotter’s
internal plots.
You are experienced at installing printers or plotters.
You don’t want to add extra memory.
For the HP DesignJet 700:
You are going to use roll media.
For the HP DesignJet 750C Plus:
You are going to use roll media and print in color.
You know whether to connect the plotter directly to your computer or to a
network and whether to use the parallel or serial interface, and you already have
the right cable.
(Serial interface users) Your computer’s RS-232-C settings are 9600 baud, no
parity, 8 data bits and 1 stop bit.
... Just Do the Following Six Steps and Skip the Rest of This Chapter.
1 Connect the power cord and switch on.
2 Load the roll of media supplied, following the instructions on the label inside
the plotter’s roll cover. Watch the front-panel display for further instructions.
3 Press
Access Cartridge(s) and open the plotter window.
For the HP DesignJet 700:
Load the black print-cartridge into the carriage on the left side of the plotter.
Don’t forget to remove the tape from the cartridge.
For the HP DesignJet 750C Plus:
Load the four color print-cartridges into the carriage on the left side of the
plotter. Don’t forget to remove the tape from the cartridges.
Setting Up the Plotter
Fast Track
700
750C Plus
700
750C Plus