Filter
Top Products
Note Make sure that the shiny side of the slide faces the scanner glass when
the TMA light source is in position on the scanner glass. (The emulsion side is
dull.)
2 If you are scanning fewer than three slides, insert the slide light shield after you
load the last slide.
Insert a slide into the slide holder with a slide light shield
Load negatives into the TMA light source
1 Load a negative strip into the negative holder. The negative holder is normally
stored in the TMA light source, within the slide holder.
Note Make sure that the shiny side of the negative faces the scanner glass
when the TMA light source is in position on the scanner glass.
Caution Negatives are easily damaged. Touch them only on their edges.
2 If you are scanning a negative strip with fewer than four frames, insert the
negative light shield after you load the negative strip. Use the arrow icons on the
negative light shield to position it correctly.
3 Load the negative strip into the negative holder.
4 Slide the negative holder into the slide holder on the bottom side of the TMA light
source.
Chapter 3
14 HP Scanjet 7600 series scanner