Filter
Top Products
11. To place the hard drive carrier back in the chassis, align the guide screws with the slots on the
drive bay, drop the carrier straight down into the drive bay (1), and press the handle on the
carrier all the way down (2) so that the drive is properly seated and locked in place.
Figure 7-25 Installing the Hard Drive Carrier
12. Replace the optical drive and reconnect the cable on the back of the optical drive.
13. Replace the computer access panel.
14. If the computer was on a stand, replace the stand.
15. Reconnect the power cord and turn on the computer.
16. Lock any security devices that were disengaged when the computer cover or access panel was
removed.
NOTE: No configuration of the SATA hard drive is necessary; the computer automatically
recognizes it the next time you turn on the computer.
Hard Drive Cage
The drive cage sits behind the USB ports on the front of the chassis.
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 143).
2. Remove the computer access panel (
Computer Access Panel on page 150).
3. Remove the optical drive and connector (
Removing the Existing Optical Drive on page 157).
4. Remove the hard drive (
Hard Drive on page 161).
164 Chapter 7 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis