Filter
Top Products
4. Remove the memory modules (Installing Additional Memory on page 153).
5. Remove the front fan (
Front Fan on page 167).
6. Remove the hard drive (
Hard Drive on page 161).
7. Remove the hard drive cage (
Hard Drive Cage on page 164).
8. Remove the front I/O panel cage:
a. Remove the screw from the right side of the cage that secures the I/O panel cage to the
front of the chassis (1).
b. Press the tab on right side of the cage (2), and then swing the right side of the cage away
from the chassis to remove it (3).
NOTE: If the cage sticks and will not come loose, press down on the top of the panel near
the tab while pressing the tab.
Figure 7-35 Removing the I/O panel cage
9. Remove the heat sink (Heat sink on page 170).
10. Disconnect all cables connected to the system board, noting their location for reinstallation.
174 Chapter 7 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis