Filter
Top Products
9
Release Notes for 07.8.04 Upgrading Software on an M2, M4, or EP Management Module to Release 07.8.04a
is displayed when the flash images are synchronized and the upgrade is complete.
4. Verify that the software has been successfully copied by entering the show flash command at any level of the
CLI:
• The software release in the primary flash is displayed at the end of the line that begins with “Compressed
Pri Code Size”.
• The software release in the secondary flash is displayed at the end of the line that begins with
“Compressed Sec Code Size”.
Ensure that software release 07.6.01b is stored in the primary or secondary flash area.
5. Reboot the routing switch to load software release 07.6.01b from the area of flash memory (primary or
secondary) where you stored it.
6. Continue with “C. Upgrading Software on a Management Module From Release 07.6.01b or Greater” to
upgrade the software to release 07.8.04a.
C. Upgrading Software on a Management Module From Release 07.6.01b or
Greater
To upgrade the software on an M2, M4, or EP management module from release 07.6.01b or greater to release
07.8.04a:
1. Verify the version of boot code running on the management module by entering the show flash command.
The boot code version is displayed at the end of the line that begins with “Boot Image size”. Ensure that boot
code version 07.06.05 is displayed.
NOTE: The show flash command only displays the version of boot code installed on the device. It does not
display the version of boot code running on the device.
If you rebooted the routing switch after installing boot code 07.06.05 (as described in “A. Upgrading Boot
Code on a Management Module to Version 07.06.05”), the required boot code is running. If you are not sure,
ProCurve recommends that you reboot the device now.
2. Store software release 07.8.04a (filename: H2R07801d.bin) on a TFTP server that the routing switch can
access.
3. Upgrade the software on the management module to version 07.8.04a by entering the following command:
copy tftp flash <ip-address> H2R07801d.bin [primary | secondary]
Where:
primary copies software to the primary (default) storage area in flash memory.
secondary copies software to the secondary storage area.
If no redundant management module is installed, the message TFTP to Flash Done is displayed when the
upgrade is complete.
If a redundant management module is installed, the message Sync Secondary code in flash...Done
is displayed when the flash images are synchronized and the upgrade is complete.
4. Verify that the software has been successfully copied by entering the show flash command at any level of the
CLI:
• The software release in the primary flash is displayed at the end of the line that begins with “Compressed
Pri Code Size”.
• The software release in the secondary flash is displayed at the end of the line that begins with
“Compressed Sec Code Size”.
Ensure that software release 07.8.04a is stored in the primary or secondary flash area.