HP (Hewlett-Packard) 9315M Switch User Manual


 
Software Fixes Release Notes for 07.8.04
30
33511 If a port in a trunk group goes down then comes up
again, the routing switch incorrectly load balances
traffic across the ports in the trunk group. In normal
operation, the switch re-balances the traffic so that
all of the ports in the trunk group are properly
utilized.
Other 07.8.01
33834 The software incorrectly attempts to free a
transmission control block (TCB) that was already
previously released. This causes the routing switch
to display a warning message on the console.
TCP Stack 07.8.01
34493 If an ACL statement contains a range of values, the
ACL log option, dscp-marking, and other ACL
options may not be available in the CLI. For
example, if you create an ACL entry that denies a
TCP port range (for example, access-list 1 deny
tcp any any range 127 129), some ACL
configuration options that are normally available
immediately following this command are not
supported.
ACL 07.8.01
34507 In an MRP configuration with four devices in a ring
and two rings in two different VLANs (for example,
one ring in VLAN 10 and another ring in VLAN 30),
an MRP ring fails to come up after a reboot.
MRP 07.8.01
07.8.01a
34160 When port mirror and monitoring is enabled, routing
to the monitor port is stopped. (Duplicate of
software fix 40149.)
Port Mirroring 07.8.01a
35710 The no web management command disables
access on port 80, but access on port 280 is
permitted.
Web
Management
07.8.01a
37911 The radius-server <hostname> command re-
orders parameters incorrectly.
RADIUS 07.8.01a
40619 The crypto random gen command is incomplete. Encryption 07.8.01a
43703 Management access is granted to a routing switch
without password verification.
Password 07.8.01a
07.8.01b
31957 When you enter the write memory command from
a Telnet session, an error message is displayed:
w_mtu_buffer_type_config_write() to
standby management jumbo e2 prom error
CLI 07.8.00 07.8.01b
33508 CPU utilization increases when you enter the show
tech command from an SSH session. As a result,
VRRP failovers and some 802.1w transitions may
occur.
VRRP-E,
RSTP, 802.1w
07.6.06 07.8.01b
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed