Filter
Top Products
39
Release Notes for 07.8.04 Software Fixes
54622 On an EP 8 Port Mini-GBIC Redundant
Management module, a port in a virtual router
interface on which an ACL is applied was changed,
added, or removed and the ACL was re-applied.
This behavior may result in a system reload.
ACL 07.8.02
54724 Installing an EP 48-Port 10/1000-TX RJ45 module
in one slot can result in a packet loss on interfaces
on a module in a different slot, on which outbound
ACLs are configured. When an outbound ACL is
configured, CAM entries are incorrectly aged out.
ACL 07.8.02
55354 On an EP 8 Port Mini-GBIC Redundant
Management module, starting in release 07.8.02,
BGP route selection is based on administrative cost
rather than selecting a local route with a lower
precedence over a BGP-advertised route from a
peer device (as in earlier releases).
BGP 07.8.02
55572 On an EP 8 Port Mini-GBIC Redundant
Management module, several topology changes
caused the system to reload. This resulted in
accessing an invalid VLAN index.
Spanning Tree 07.8.02
55689 When you enter the ip access-group 0 in
command, all configured ACL entries are removed
from physical and virtual routing interfaces.
ACL 07.8.02
55772 The routing switch performed a system reload
triggered by the watchdog timer when a large
number of CAM entries were aged out.
System 07.8.02
55773 A system reload occurs when an ACL is modified to
re-assign traffic to a different priority queue.
ACL 07.8.02
56078 Valid values for Virtual Router Redundancy Protocol
Extended (VRRPE) slow-start are 1-255, but the
values 0 to 65535 can be entered.
VRRPE 07.8.02
56079 When ACL clauses are configured with the IP
address 0.0.0.0 and with varying masks, the mask
is not checked when you delete the clauses.
ACL 07.8.02
56080 ACLs configured with clauses containing DSCP
mapping or priority mapping do not match the
DSCP map or priority mapping field. As a result, if
there are multiple clauses, packets are matched
incorrectly.
ACL 07.8.02
56083 If you delete an EP 8 Port Mini-GBIC Redundant
Management module and then re-insert the module
back into the device after the aggregated-vlan
command and the default maximum transmission
unit (MTU) value are configured, the MTU changes
back to the default value after the insertion.
System 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed