Filter
Top Products
Software Fixes Release Notes for 07.8.04
56
75878 Module: N/A
Symptom:
In a Switch or Router if the SSH is used for
management, occasionally this can cause a system
reset.
Resolution: Fixed in this release.
SSH 07.8.03d
76577 Module: N/A
Symptom: In a Switch or Router configured with
UDLD and Holddown Threshold, if the UDLD
configured interface is disabled due to reaching the
threshold, the UDLD KeepAlive packets continue to
be sent out causing the remote end to falsely keep
the UDLD interface active.
Resolution: Fixed in this release.
UDLD 07.8.03d
72430 Module: N/A
Symptom: In a Router configured with VRRP, the
ICMP PING is not responded to when the VRID on
the interface configured with the Master VRRP is
disabled.
Resolution: Fixed in this release.
VRRP 07.8.03d
07.8.03e
74759 Module: N/A
Symptom: In a Switch or Router, when an extended
Access Control List is configured using a port range
for the Source Port and the Destination Port, the
Access Control List is incorrectly saved in the
configuration.
Resolution: Fixed in this release.
ACL 07.8.03e
77627 Module: N/A
Symptom: In a Switch or Router configured with a
Redundant Management Module, the configuration
file is not synchronized when executing the “Write
Memory” command. The following error message is
seen:
Sync config data in flash...Flash is in use, aborted
Resolution: Fixed in this release.
System 07.8.03e
07.8.03f
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed