Filter
Top Products
Software Fixes Release Notes for 07.8.04
44
59468 If OSPF is configured, the OSPF configuration is
not displayed in show ip ospf config command
output until the configuration is saved and the
switch is rebooted.
OSPF 07.8.02
59698 If SSH is configured, a system reload sometimes
occurs due to insufficient stack space.
SSH 07.8.02
59925 The incorrect deletion of CAM entries may cause a
routing switch to reload.
System 07.8.02
60117 If you enable the VSRP and CPU Protection
features, when a link flaps, the VSRP forwarding
state is not correctly set. As a result, the CAM for
the master is not updated correctly, resulting in a
Layer 2 packet loop.
VSRP 07.8.02
60227 When you configure an incorrect speed on a virtual
interface, the valid physical port is not checked,
resulting in a system reload.
System 07.8.02
60249 If BGP4 is configured and a BGP update is received
for an existing prefix, in some cases the BGP route
does not include the BGP tree node. This can
cause the system to reload.
BGP4 07.8.02
60330 If a large number of VLANs are configured, when
you remove or add a tagged port from a VLAN, high
CPU utilization occurs.
System 07.8.02
60396 When a static MAC address is configured on
multiple ports, the address is not displayed on all
ports in show mac ethernet <slot/port> command
output.
System 07.8.02
60401 When you configure a username password using all
numeric characters, it is necessary to re-enter the
service password-encryption command after you
add each password.
To create an MD5 password, use one of the
following commands:
• username <username> create-password
<password-string>
• username <username> privilege <number>
create-password <password-string>
Both commands generate the same syntax.
• username <username> password <number>
<encryptedpassword-string>
Or
• username <username> privilege <number>
password <
number> <encrypted-password-
string>
System 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed