Filter
Top Products
Software Fixes Release Notes for 07.8.04
42
58868 You cannot disable the HP Discovery Protocol
(FDP) or Cisco Discovery Protocol (CDP) on a
secondary trunk port if you have entered the no fdp
enable or no cdp enable command on a primary
trunk port.
FDP and CDP 07.8.02
58909 A route learned via RIPv1 disappears if a port in the
RIPv1 route has a statically added route.
RIPv1 07.8.02
59169 A routing switch does not properly flush the PIM
mcache after an MRP master goes down. As a
result, packets are forwarded to the interface on
which they are dropped.
PIM 07.8.02
59519 When OSPF is configured on fixed full-duplex (10-
Full or 100-Full) interfaces, the external route
summarization fails when the configuration is
loaded during system boot.
OSPF 07.8.02
59698 On an EP 8 Port Mini-GBIC Redundant
Management module, the incorrect MAC address
that is used in an unsuccessful SSH session is
displayed in show log command output.
SSH 07.8.02
59749 When you enter the OSPF area range advertise
command, a specific summary route is not
advertised if a route first matches another area
range command that has a less specific route.
ACL 07.8.02
59925 If CAM entries are inconsistent on a routing switch,
a system reload can occur when you enter the no
vlan command.
VLAN 07.8.02
60057 On an EP 8 Port Mini-GBIC Redundant
Management module, OSPF external routes are not
matched correctly with the subnet mask. As a
result, these routes are incorrectly deleted.
Other 07.8.02
60249 When a new BGP route is being processed in a
routing switch, the BGP route is missing from the
Patricia Tree in some error situations. This may
cause a system reload when the route is added to
the BGP routing table.
BGP 07.8.02
60277 When a large number of CAM entries are being
processed on an EP 8 Port Mini-GBIC Redundant
Management module, a system reload may occur.
System 07.8.02
60330 The routing switch either performs a software reload
or locks the console for 40 seconds when you add
or remove ports from a VLAN.
ACL 07.8.02
60358 On an EP 16-Port 10/1000-T module, if the routing
switch detects a BGP AS path pointer to be invalid,
the switch resets the pointer to Null.
BGP 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed