HP (Hewlett-Packard) 9315M Switch User Manual


 
Software Fixes Release Notes for 07.8.04
38
49141 On an EP 8 Port Mini-GBIC Redundant
Management module, you cannot reassign the
same interfaces to an MRP ring.
MRP 07.8.02
49240 On a 2-Port 10 Gigabit Ethernet module, when you
configure a jumbo MTU, packet loss may result
when a link on a 10 Gigabit port is removed and re-
inserted.
System 07.8.02
49461 On an EP 8 Port Mini-GBIC Redundant
Management module, transient Ring Health packets
(RHPs) are flushed during a topology change,
causing high CPU usage.
MRP 07.8.02
50203 When MRP2 is configured, the routing switch does
not flush out learned MAC addresses during
topology changes, even if the device receives a
Topology Change (TC) packet.
MRP 07.8.02
50541 On an EP 8 Port Mini-GBIC Redundant
Management module on a POE switch, network
latency jumps from sub-millisecond to 300+
milliseconds when MAC filters are applied.
System 07.8.02
50550 On an EP 8 Port Mini-GBIC Redundant
Management module, when you remove the trunk
port mirroring configuration, a trunk port continues
to mirror outbound packets.
Port Mirroring 07.8.02
50685 Applying outbound rate limiting on a port several
times may cause that port to toggle between a link
up or link down state.
Rate Limiting 07.8.02
50735 On an EP 48-Port 10/1000-TX RJ45 module, the
show rate hardware command output does not
display the rate limiting that was configured on the
port.
Rate Limiting 07.8.02
52810 On an EP 8 Port Mini-GBIC Redundant
Management module, if an ACL with a DiffServ
Control Point (DSCP) mapping is applied to a virtual
routing interface, the ACL incorrectly matches the
VLAN. This causes control packets, such as OSPF
packets, to be discarded.
OSPF 07.8.02
53602 Uni-Directional Link Detection (UDLD) does not
function properly or does not recover after a system
reload.
UDLD 07.8.02
54375 Entering the no untag command with the qos-tos
trust DSCP attribute may cause a stack overflow,
which can result in a system reload.
System 07.8.02
54502 A routing switch that has 802.1w and many VLANs
configured lost one link in a trunk group, causing a
console lockup and topology change.
VLAN 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed