Filter
Top Products
Software Fixes Release Notes for 07.8.04
46
62894 If the ports within a trunk are disabled due to a port
security violation, the disable command is not
displayed as part of the show running-config
command output.
Port Security 07.8.02
63138 On an interface on which both sFlow and an
inbound ACL are configured, in the display of sFlow
traffic statistics, the number of packets received is
lower than the actual number received.
sFlow 07.8.02
63138 The following debug message may incorrectly be
displayed on the console:
Warning: Shadow CAM data Entry
System 07.8.02
63525 When you configure IP multicast snooping on a
routing switch, the switch can perform a system
reload due to corruption of multicast snooping
database entries.
IP Multicast
Snooping
07.8.02
63525 When you enable IGMP snooping by entering the ip
multicast active and ip multicast filter
commands, a routing switch performs a system
reload.
PIM Dense 07.8.02
64104 When a routing switch is configured with output
ACLs, sFlow, and multi-slot trunks, the
management module may show high CPU usage.
ACL 07.8.02
64169 If sFlow is configured and a broadcast or multicast
packet is sampled for exporting, it may cause the
management module to reset.
sFlow 07.8.02
07.8.02c
61801 If BGP4 is configured, when an aggregate route is
advertised using a route map that contains the as-
set and summary-only attributes, the advertised
route does not inherit the AS number from the
component routes.
BGP4 07.8.02
62627 If IP routing is configured, the addition of a static
route via an SNMP set request does not install an
IP route in the routing table.
SNMP 07.8.02
63329 If trunk and port security are configured and you
have not entered the config-trunk-ind command to
enable or monitor individual trunk ports, a violation
on a secondary member disables only one of the
members.
Port Security 07.8.02
63429 When a configuration file containing an ACL is
downloaded via TFTP on a routing switch, the
system may reload.
ACL 07.8.02
63629 If OSPF is configured, the show ip ospf routes
command displays the last route twice.
OSPF 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed