Filter
Top Products
Removal and replacement procedures
Maintenance and Service Guide 4–13
2. Use the Mylar tab 1 to slide the hard drive to the left 2, and then disconnect the hard drive cable 3 from the
system board.
3. Remove the hard drive 4 from the hard drive bay.
4. If it is necessary to replace the hard drive bracket or any of the hard drive bracket components, remove the two
Phillips PM3.0×4.0 screws 1 from each side of the hard drive.
5. Lift the bracket 2 straight up to remove it from the hard drive.
✎
The four rubber isolators 3 located on the ends of the bracket may also be replaced.
Reverse this procedure to install the hard drive.