Filter
Top Products
4–48 Maintenance and Service Guide
Removal and replacement procedures
TV tuner module cable
✎
The TV tuner module cable is available in the Cable Kit, spare part number 516328-001.
Before removing the TV tuner module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
“Battery” on page 4-7).
5. Remove the following components:
a. Primary and secondary hard drive covers (see
“Hard drive covers” on page 4-9)
b. Primary and secondary hard drives (see
“Hard drive” on page 4-12)
c. Optical drive (see
“Optical drive” on page 4-8)
d. WLAN module (see
“WLAN module” on page 4-15)
e. Switch cover and keyboard (see
“Switch cover and keyboard” on page 4-21)
f. Display assembly (see
“Display assembly” on page 4-28)
g. Top cover (see
“Top cover” on page 4-37)
h. System board (see
“System board” on page 4-40)
i. USB board (see
“USB board” on page 4-46)
Remove the TV tuner module cable:
1. Release the clips 1 built into the base enclosure that secure the TV tuner antenna connector.
2. Remove the TV tuner module cable from the clips and routing channel 2
built into the base enclosure.
3. Remove the TV tuner module cable 3 from the base enclosure.
Reverse this procedure to install the TV tuner module cable.