Filter
Top Products
4–14 Maintenance and Service Guide
Removal and replacement procedures
Memory module
Before removing the memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
“Battery” on page 4-7).
5. Remove the primary hard drive cover (see
“Primary hard drive cover” on page 4-9).
Remove the memory module:
✎
This computer has both primary and expansion memory module slots. The top memory module slot is for
expansion memory and the bottom slot is for primary memory. The following procedure can be used to remove
memory modules from either slot.
1. Spread the retaining tabs 1 on each side of the memory module slot to release the memory module. (The edge
of the module opposite the slot rises away from the computer.)
2. Remove the module 2 by pulling it away from the slot at an angle.
✎
Memory modules are designed with a notch 3 to prevent incorrect insertion into the memory module slot.
Reverse this procedure to install a memory module.
Description Spare part number
4096-MB SDRAM (DDR2, 800-MHz, PC2-6400, 1-DIMM) 582087-001
2048-MB (DDR2, 800-MHz, PC2-6400, 1-DIMM) 582086-001
1024-MB (DDR2, 800-MHz, PC2-6400, 1-DIMM) 582085-001