Filter
Top Products
Removal and replacement procedures
Maintenance and Service Guide 4–33
✎
Steps 22 through 34 provide display panel removal information for computer models equipped with AntiGlare
display assemblies. See steps 6 through 21 for display panel removal information for computer models equipped
with BrightView display assemblies.
22. If it is necessary to replace the display bezel or any of the AntiGlare display assembly internal components,
remove the following screw covers and screws:
a. Two rubber screw covers 1 on the display bezel bottom edge. The display rubber screw covers are included
in the Display Rubber Kit, spare part number 516308-001.
b. Four Phillips PM2.5×7.0 screws 2.
23. Turn the display assembly upside down, with the bottom edge toward you.
24. Separate the bottom edge of the display enclosure from the display bezel 1, and slide the enclosure 2 down far
enough to display the four screws that secure the bottom cover to the display assembly.
25. Remove the four Phillips PM2.5×4.0 screws 3, and then remove the bottom cover 4 from the display
assembly.