Filter
Top Products
Light status State of the product Action
Ready light is blinking, and attention
light is off.
The product is receiving or processing
data.
No action is required. The product is
receiving or processing a print job.
Attention light is blinking, and ready
light is off.
The product has experienced an error that
can be corrected at the product, such as
a jam, an open door, the absence of a
print cartridge, or the absence of paper in
the proper tray.
Inspect the product, determine the error,
and then correct the error. If the error is
the absence of paper in the proper tray or
the product is in a manual feed mode, put
the proper paper in the tray and follow the
onscreen instructions, or open and close
the print-cartridge door to resume
printing.
Attention light is blinking, and ready
light is on.
The product has experienced a continual
error from which it will recover on its own.
If the recovery is successful, the product
continues to the processing data state
and completes the job.
If the recovery is unsuccessful, the
product continues to the continuable
error state. Try removing any media from
the media path and turning the product
power off, and then on again.
The attention and ready lights are on. The product has experienced a fatal error
from which it cannot recover.
1. Turn off the product or disconnect
the power cord from the product.
2. Wait 30 seconds, and then turn on
the product or reconnect the power
cord to the product.
3. Wait for the product to initialize.
If the error persists, contact HP customer
support. See
Customer support
on page 102.
Table 8-2 Control-panel light patterns (continued)
ENWW Interpret control-panel light patterns 71