Filter
Top Products
Verify that Resistor Packs are Properly Installed
A SCSI bus has two ends between which SCSL devices are attached. Each end of a SCSI
bus must be terminated with a resiitor network, or “terminator”. The adapter card contains
two resistor packs mounted in sockets on the card. These resistor packs act as a terminator
for one end of the SCSI bus.
Note
The SCSI port is supported for use only on the end of a SCSI bus. The
two resistor packs must be installed.
Visuaily verify that the two resistor packs are installed with the proper orientation. The
resistor packs are marked with a dot on one end and should be oriented as shown in figure
1-5.
Termination Resistors,
Figure l-5. Proper Resistor Pack Orientation
l-10 installing the Adapter