Filter
Top Products
To do… Use the command… Remarks
Specify the service type for the
local user
service-type terminal
Required
By default, no service type is
specified.
Configure common settings for
AUX user interface view
—
Optional
See “Configuring common settings
for console login (optional).”
After you enable command authorization, you need to perform the following configuration to make the
function take effect:
• Create a HWTACACS scheme, and specify the IP address of the authorization server and other
authorization parameters. For more information about AAA, see the Security Configuration Guide.
• Reference the created HWTACACS scheme in the ISP domain. For more information about AAA,
see the Security Configuration Guide.
After you enable command accounting, you need to perform the following configuration to make the
function take effect:
• Create a HWTACACS scheme, and specify the IP address of the accounting server and other
accounting parameters. For more information about AAA, see the Security Configuration Guide.
• Reference the created HWTACACS scheme in the ISP domain. For more information about AAA,
see the Security Configuration Guide.
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
• When the AAA scheme is local, the user privilege level is defined by the authorization-attribute
level level command.
• When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the
RADIUS or HWTACACS server.
• For more information about AAA, RADIUS, and HWTACACS, see the Security Configuration
Guide.
When you log in to the device through the console port after the configuration, you are prompted to enter
a login username and password. A prompt such as <HP> appears after you input the password and
username and press Enter, as shown in
Figure 11.
33