Filter
Top Products
Displaying and maintaining web login
To do… Use the command… Remarks
Display information about web
users
display web users [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display HTTP state information
display ip http [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display HTTPS state information
display ip https [ | { begin | exclude |
include } regular-expression ]
Available in any view
Web login example
HTTP login example
Network requirements
As shown in Figure 27, the PC is connected to the device over an IP network. The IP address of the Device
is 192.168.20.66/24.
Figure 27 Network diagram for configuring HTTP login
Configuration procedure
1. Configuration on the device
# Log in to the device via the console port and configure the IP address of VLAN 1 of the device. VLAN
1 is the default VLAN.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-VLAN-interface1] ip address 192.168.20.66 255.255.255.0
[Sysname-VLAN-interface1] quit
# Create a local user named admin, and set the password to admin for the user. Specify the Telnet
service type for the local user, and set the command level to 3 for this user.
[Sysname] local-user admin
[Sysname-luser-admin] service-type telnet
[Sysname-luser-admin] authorization-attribute level 3
[Sysname-luser-admin] password simple admin
2. Configuration on the PC
# On the PC, run the web browser. Enter the IP address of the device in the address bar, 192.168.20.66
in this example. The web login page appears, as shown in Figure 28.
70