Filter
Top Products
Step6
Character string CONNECT9600 is displayed on the terminal. Then a prompt appears when you press
Enter.
Figure 23 Configuration page
Step7 If the authentication mode is password, a prompt (for example, HP) appears when you type the
configured password on the remote terminal. Then you can configure or manage the router. To get help,
type ?.
Step8 Execute commands to configure the device or check the running status of the device. To get help, type ?.
NOTE:
• To terminate the connection between the PC and device, execute the ATH
command on the terminal to
terminate the connection between the PC and modem. If you cannot execute the command on the
terminal, input AT+ + + and then press Enter. When you are prompted OK, execute the ATH command,
and the connection is terminated if OK is displayed. You can also terminal the connection between the
PC and device by clicking
on the hyper terminal window.
• Do not close the hyper terminal directly. Otherwise, the remote modem may always be online, and you
will fail to dial in the next time.
Modem login authentication modes
The following authentication modes are available for modem dial-in login: none, password, and
scheme.
• none—Requires no username and password at the next login through modems. This mode is insecure.
• password—Requires password authentication at the next login through the console port. Keep your
password.
• scheme—Requires username and password authentication at the next login through the console port.
Authentication falls into local authentication and remote authentication. To use local authentication,
configure a local user and related parameters. To use remote authentication, configure the username
55