Filter
Top Products
Introduction
Power Management
1-9
To reset the OmniBook
If Windows or the OmniBook stops responding, you can reset the OmniBook and
restart Windows.
1. If possible, shut down Windows.
2. Press the blue power button for 4 seconds.
–or, if this fails–
Insert a pen or straightened paper clip into the recess on the back panel
between the Parallel and Video ports.
3. After the computer shuts down, press the blue power button to turn it on.
To set up a hibernation partition
There must be a hibernation partition large enough to hold the contents of memory
on the hard disk before the OmniBook can hibernate. By default the hibernation
partition is 144 MB, large enough to hold the maximum amount of memory allowed
in the OmniBook 3000. If you have repartitioned the hard disk, purchased a new
hard disk or would like to make the partition smaller follow the instructions below.
CAUTION
This procedure erases the hard disk. Be sure to save any data on your hard disk
before started this procedure.
1. Insert the OmniBook 3000 CD-ROM drive.
2. Connect the ac adapter to the OmniBook.
3. Turn on the OmniBook.
4. Press Esc during the Boot process.
5. Insert the OmniBook 3000 Recovery CD.
6. Press the System Off button on the back panel.
7. Press the blue Power button.
8. Press the Esc key during the boot process.