Filter
Top Products
Connect the product to a network
Supported network protocols
To connect a networking-equipped product to a network, you need a network that uses one or more of
the following protocols.
●
TCP/IP (IPv4 or IPv6)
NOTE: While this product can be used over IPv6 networks, a product software installation from
the CD is not supported over IPv6 networks.
●
LPD Printing
●
SLP
●
WS-Discovery
●
HP Wireless Direct
Install the product on a wired network
Use this procedure to install the product on a wired network.
Obtain the IP address
1. Connect the ehternet cable to the product and to the network. Turn the product on.
2. Wait for 60 seconds before continuing. During this time, the network recognizes the product and
assigns an IP address or host name for the product.
3.
At the product control panel, press the Setup
button.
4. Touch the Print Reports menu, and then touch the Network Configuration Page menu item to print
the configuration report.
ENWW
Connect the product to a network
31