Hitachi CP-X3021WN Projector User Manual


 
20
3.1 Projector Web Control - Network Settings (continued)
3. Web Control
Item 'HVFULSWLRQ
Wireless Setup Congures the wireless LAN settings.
Mode Select
"
AD-HOC" or
"
Infrastructure".
,3&RQ¿JXUDWLRQ Congures network settings.
'+&321 Enables DHCP.
'+&32)) Disables DHCP.
IP Address Congures the IP address when DHCP is disabled.
Subnet Mask Congures the subnet mask when DHCP is disabled.
'HIDXOW
Gateway
Congures the default gateway when DHCP is disabled.
'166HUYHU$GGUHVV Congures the DNS server address.
Ch
Select from “1” to “11” a channel to use in the AD-HOC mode.
Encryption Select data encryption method.
WEP Key
Input the WEP key.
Either ASCII characters or hexadecimal numbers can be
used during WEP key input. However, you cannot use a
combination of both.The length of the key is dened as
follows according to the WEP and character formats.
Encryption ASCII characters HEX numbers
WEP 64bit 5 characters 10 characters
WEP 128bit 13 characters 26 characters
WPA Passphrase
Input WPA Passphrase.
Available number of input characters is 8 to 63. Only
alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@ [\]^_`{|}~ and space
66,'
Select an SSID from the list.
If you require to set your unique SSID, select [Custom], then
set your own SSID following the rules below.
Maximum number of input characters is 32.
Only alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@[\]^_`{|}~ and space.
(continued on next page)
• Depending on the country where you are
the channels may vary. In addition, depending on the
country or region where you are may be required to use a
wireless network card that conrm to the standards in the
respective country or region.
NOTE