Hitachi CP-X3021WN Projector User Manual


 
7
ENGLISH
Connecting with your devices
Before connecting the projector to a device, consult the manual of the device to
conrm that the device is suitable for connecting with this projector and prepare
the required accessories, such as a cable in accord with the signal of the device.
Consult your dealer when the required accessory did not come with the product or
the accessory is damaged.
After making sure that the projector and the devices are turned off, perform the
connection, according to the following instructions. Refer to gures F-3 to F-6 at the
end of this manual.
For details, see User’s Manual - Operating Guide. Before connecting the projector
to a network system, be sure to read User’s Manual - Network Guide too.
WARNING Use only the appropriate accessories. Otherwise it could
cause a re or damage the projector and devices.
Use only the accessories specied or recommended by the projector’s
manufacturer. It may be regulated under some standard.
Neither disassemble nor modify the projector and the accessories.
Do not use the damaged accessory. Be careful not to damage the accesso-
ries. Route a cable so that it is neither stepped on nor pinched out.
CAUTION For a cable with a core at only one end, connect the end with
the core to the projector. That may be required by EMI regulations.
Before connecting the projector to a network system be sure to obtain the
consent of the administrator of the network.
Do not connect the LAN port to any network that might have the excessive
voltage.
The designated USB wireless adapter that is sold as an option is required to
use the wireless network function of this projector.
Before removing the USB storage device from the port of the projector, be
sure to use the REMOVE USB function on the thumbnail screen to secure your
data. Before you insert or pull out the USB wireless adapter from the projector,
turn off the power of the projector and pull out the power cord’s plug from the
outlet. Do not touch the USB wireless adapter while the projector is receiving
AC power.
NOTE Do not turn on or off the projector while connected to a device in
operation, unless that is directed in the manual of the device.
• Some input ports are selectable in the use. For details, see User’s Manual -
Operating Guide.
• Be careful not to mistakenly connect a connector to a wrong port.
• If an oversized USB storage device blocks the LAN port, use a USB extension
cable to connect the USB storage device.