Filter
Top Products
1. Raise the ADF input tray until it clicks into place.
2. Lift the green lever slightly, and then slide the imprinter to the position that you want.
NOTE: Several paper sizes are indicated in the imprinter carriage. If you set the
imprinter at the position for the paper size that you are using, the imprinter mark
is printed about 5 mm (.2 in) from the side of the page. You can select any position
that prints on the size of the paper that you are using. If you leave the imprinter
between the marked positions, the imprinter might shift during scanning, and the
imprinter mark will be of poor quality.
3. Grasp the center of the ADF input tray, and then lower the ADF input tray into position
for scanning.
Test the imprinter
Test the imprinter to verify that the print cartridge is loaded properly and to check the
placement of the imprinter mark on the page.
NOTE: To prevent the counter value from changing during the test, the imprinter test
prints a preset mark in the configured location.
Chapter 2
20 Useful scanner features