Filter
Top Products
35
Wake Activation Area (Photocell LED Output)
The MS2420/MS2430 scanner’s default power save mode
†
43 is Dual Action Power Save Mode #2 (see page ).
This power save mode turns the laser OFF after a configured period of non-use then turns the motor OFF after
thirty-minute intervals. Any movement detected by the photocell in the activation area, shown below in grey,
will cause the scanner to exit the power save mode. The motor will restart automatically and the laser will turn
back on preparing the scanner for bar code recognition, decoding, and transmission.
Figure 29. Wake Activation Area Perpendicular to Package Flow Default Range
(Photocell LED Output)
† Refer to the MetroSelect Configuration Guide (PN 00-02407) for additional information on configurable
power save modes.
Specifications are subject to change without notice.