Filter
Top Products
7–10
³ 1 4 1 7 1 5
Use Protocol Prefix and Suffix for Bar Code
Transmission
³ 1 4 1 7 0 5
* No Protocol Prefix and Suffix for Bar Code
Transmission
³ 1 1 9 9 1 7
Enable RTS on No Read
– After a NOREAD
occurs, the scanner will activate the RTS line for
20 milliseconds. The duration of the RTS
activation can be loaded in address 199 bits 6–0
in 10 millisecond steps.
³ 1 1 9 9 0 7
* Disable RTS on No Read
Test Modes
³ 1 1 8 0 1 6
Scan Count Mode ON – The scanner will enter
scan count test mode and the scanner’s firmware
number will transmit to the host. Do not enable
unless instructed by a Honeywell representative.
³ 1 1 8 0 0 6
* Scan Count Mode OFF
³ 1 1 5 5 1 2
Power-Up with Saved Interface – Do not
enable unless instructed by a Honeywell
representative.
³ 1 1 5 5 0 2
* Power-Up with Board Interface – Do not enable
unless instructed by a Honeywell representative.