Filter
Top Products
15–1
USB
³ 4 1 5 5 1 1 4
Enable USB Interface
♦
³ 9 9 9 9 7 8
Enable Low Speed USB Defaults
♦
♦ This feature is limited to Honeywell scanners without integrated Low Speed
USB electronics. These bar codes configure the scanner to communicate
via the MX009.
³ 9 9 9 9 4 0
Load Integrated Full Speed USB Keyboard
Emulation Defaults
³ 9 9 9 9 7 0
Load Integrated Full Speed USB IBM/OEM
Defaults
³ 9 9 9 9 3 1
Load Integrated Low Speed USB OPOS Defaults
Feature is limited to scanners with internal
Low-Speed USB interfaces with specific software
versions.
³ 3 1 6 4 3 0
IBM OEM Scanner 4B00h Hand-Held – Full
Speed USB Only
³ 3 1 6 4 0 1 0
IBM OEM Scanner 4A00h Flat-Bed – Full
Speed USB Only
³ 3 1 6 4 0 0
* Enable USB Keyboard Emulation Mode
Note: USB Keyboard Emulation Mode is a factory default. If the Recall
Defaults bar code is scanned while reconfiguring the scanner, the
scanner configuration will revert to the factory default setting
discarding any previous configuration settings for USB Serial
Emulation. To enable the Serial Emulation Mode, rescan the
Bi-Directional or Uni-Directional USB Serial Emulation Mode bar code
on page 15–2.
15