Filter
Top Products
HotBrick, Tel: 305
-
398
-
0888, Fax: 305
-
398
-
5966
3 : Loadbalancing
This screen is only operational if using Internet connections on both WAN ports
Figure 3-2: Load Balance
Load balancing – Load Balancing
Enable – Use this to enable your Load Balance settings. Unless this is checked, the other
settings on this screen have no effect.
Balance Type – Select the desired option:
• Bytes rx+tx – Traffic is measured by Bytes.
• Packets rx+tx – Traffic is measured by Packets.
• Sessions established – Traffic is measured by Sessions.
• IP Address – Traffic is measured by IP Address.
Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent over WAN 1. If one
WAN port connection has greater bandwidth than the other, the one with the greater bandwidth
should be given a higher percentage of traffic than the other.
NAT statistics This section displays the current data about WAN 1 and WAN 2. You can use this
information to help you "fine-tune" the settings above.
Interface statistics This section displays cumulative statistics. Use the "Restart Counters" button
to restart these counters when required.
19