Filter
Top Products
HotBrick, T
el: 305
-
398
-
0888, Fax: 305
-
398
-
5966
settings to correct the problem.
Enable - If enabled, the WAN port you specify will be used for all outgoing SMTP
traffic. If disabled, either WAN port will be used.
WAN – Select the desired WAN port to be bound.
Protocol and Port Bindings - Use these settings if you wish to ensure that particular traffic
is sent by a particular WAN port, and thereby a particular ISP account.
Enable - Enable or disable each item as required.
Source IP - IP address of the source sending the packets.
Destination IP – IP address of the destination receiving the packets.
Subnet Mask – With a subnet mask other than 255.255.255.255, you can make an IP subnetwork
your destination.
Protocol – Select protocol type used by the traffic you wish to configure.
Port Range - Enter the beginning and end of the port range used by the traffic you wish to
configure. If only a single port is used, enter the port number in both fields.
WAN - Select the WAN port you wish this traffic to use.
Protocol and Port Binding List - This list shows the details of all protocol and port configuration data
that are currently defined. You can modify them by mouse clicking the correct row.
39