Filter
Top Products
5. HRView Operating Guide HRView Function Manual
5-4
5.3. Communication Setup and Connection
Click , and communication setup dialog box will appear.
Fig 5.3 Communication setup dialog box
① Click to control the connection status. If this button is pressed, this
means connected status. If not, this means disconnected status.
② As to RS-232C, set each communication parameter (it should be the same as that of
the controller) on the left in the disconnected status, click button, and
click to end. Cable should be connected to the communication port.
③ As to Ethernet, enter IP address and port number in the disconnected status, click
button, and click to end. IP addresses and port numbers of
many controllers can be managed by using list box, and .