Filter
Top Products
Attention:
v Attach a wrist strap to an unpainted surface of your hardware to prevent electrostatic discharge
(ESD) from damaging your hardware.
v When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It
does not increase or decrease your risk of receiving electric shock when using or working on
electrical equipment.
v If you do not have a wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted surface of the system for a minimum of 5
seconds.
4. Align the power supply with the power supply bay and slide the power supply into the system until
it locks into place.
5. Attach the power cable (A), as shown in Figure 5.
6. Note the state of the light-emitting diodes (LEDs) on the power supply. For more information, see
“Power supply LEDs” on page 8. If the LEDs indicate that the power supply is operating normally,
that is, the AC input LED and the DC output LED are on solid (not flashing) and the fault/identify
LED is flashing or off, continue to the next step. If not, remove the power supply from the system and
repeat the procedure starting with step 4. If, after repeating the procedure, the power supply is not
operating normally, contact your service provider.
Figure 5. Replacing the power supply
Power supplies 7