Filter
Top Products
7. Close the rear rack door.
Related information
Before you begin
Power supply LEDs
The various states of the power supply light-emitting diodes (LEDs) can be used to identify or verify a
power supply that you are servicing.
The power supply has three LEDs that indicate the power supply status:
v an ac power LED (green, at the right of the 3 LEDs)
v a dc power LED (green, in the middle of the 3 LEDs)
v an error and identify function LED (amber, at the left of the 3 LEDs)
To locate the power supply LEDs, look on the top or at the back of an exposed power supply. You must
remove covers or panels to expose the power supply. Follow the instructions to remove covers or panels
for the power supply you are working with, and then return here.
To activate the identify function, see “Identifying a part” on page 36.
Descriptions for the states of the power supply LEDs follow:
v If both the ac power and dc power (green) LEDs are on solid (not flashing) and the error and identify
function (amber) LED is off, the power supply is operating correctly.
v If the ac power LED is on, the dc power LED is flashing, and the error and identify function (amber)
LED is off, then the system is turned off, but the power supply is still connected to the power source.
v If the error and identify function (amber) LED is flashing, the power supply identify function has been
selected.
Figure 6. Power supply LEDs
8 Power Systems: Power supplies for the 9117-MMB or 9179-MHB